What are the characteristics of quasi hyperbolic gear?

Quasi hyperbolic gear industry development prospects are very good, because in the use of time for the benefits of the enterprise more, so by the customers of all ages, in order to make you more familiar with it, then we will tell you about the characteristics of quasi hyperbolic gear what are.

Nowadays, there are still many people who do not know some basic information about quasi-hyperbolic gears, so as manufacturers, it is also necessary for us to briefly explain. In fact, quasi-hyperbolic gears are used for transmission between two shafts with wrong axes. Generally speaking, the distance between the axis of the small wheel and the axis of the large wheel is called the offset distance, which is expressed by E. In the future, when you get stuck in it, at least you should know that in the general regulations, when facing the teeth of the big wheel, the small wheel can be placed horizontally on the right side of the big wheel. If the axis of the small shaft is below the axis of the big wheel, it is called downward offset, otherwise it will be upper offset. The direction of the bias of the quasi-hyperbolic gear is generally taken to increase the helix angle of the small wheel. For users, what we need to know is that its offset distance increases, the helix angle of the small wheel also increases, and the outer diameter of some small wheels also increases. In this way, the rigidity and strength of the small wheel can be improved, and in this case, the number of teeth of the small wheel can be naturally reduced, and a high reduction ratio transmission can be obtained. If you have something you don't understand, you can call us at any time to consult. You can see the contact information when you enter the official website. You can also consult the online customer service personnel.

In addition, this quasi-hyperbolic gear has an offset distance, which makes the transmission design layout more flexible. In fact, its characteristics are also reflected in different places. At the same time, the strength of the small wheel can also be improved. The hypoid gear pair small wheel recommend for everyone today has a larger helix angle to make it more overlapping when meshing, and when it is working, you will find that its transmission is actually more stable. In the transmission process, it is also possible to have relative sliding along the tooth length direction and the tooth height direction, so that the workpiece grinding process after heat treatment is better. However, because the relative sliding is larger than the bevel teeth, the possibility of early wear is also greater, so pay attention to the selection of lubricating oil. The distance measured along the back cone generatrix between the tip circle and the root circle of a quasi-hyperbolic gear. Generally speaking, when a pair of bevel gears mesh with each other, there is an intersection point between the tooth top circle and the back cone generatrix. Of course, the short distance between the two intersection points is measured along the common generatrix. At present, the wide application of its instrument in daily life and its better and better production technology also make us believe that more and more manufacturers will join in, so we should see more and compare more.

The content of the above article is the characteristics of quasi-hyperbolic gears introduced by the editor. If you are curious, please take a look. I believe it will definitely not disappoint you. That's all for today's content. I hope I can help you.