Right angle planetary reducer manufacturers to explain to you the matters needing attention in the operation of the reducer

Right Angle Planetary Reducer Manufacturer: Precautions for Installation and Trial Operation of Reducer

Reducers are widely used in all walks of life. What are the installation and precautions of the reducer? We believe that ensuring installation and paying attention to problems in use can save users time.

1. The transmission coupling of the reducer should be equipped with protective devices if necessary, such as protrusions on the coupling or gear and sprocket transmission. If the output shaft bears a large radial load, it should also be strengthened.

There are many kinds of couplings used in the reducer, but do not use rigid couplings. The installation of such couplings is very difficult. Once installed improperly, the load will increase, which will easily lead to bearing damage and even output shaft fracture.

3. When installing the transmission parts on the output shaft of the reducer, pay attention to the gentle operation. Do not use tools such as hammers for rough installation. When installing, use the assembly fixture and the internal thread of the end shaft, and press the transmission parts into the reducer with the force of bolts. In order to protect the internal parts of the reducer from damage.

4. Before the reducer runs, it must be ready for operation, remove the exhaust plug of the oil pool, replace the exhaust plug, open the screw of the oil level plug, check the oil level, add the oil level plug to the lubricating oil screw hole until it overflows, then screw on the oil level plug, and start the trial operation after confirming that it is correct.

5. The installation position of the reducer should ensure the operation of the workers, including the convenient access of the cursor, the exhaust plug and the oil drain plug. After the reducer is installed, the inspector should check the accuracy of the installation position to determine each fastener Reliability.

6. The trial operation time of the reducer shall not be less than 2 hours. The standard for normal operation is smooth operation, no vibration, no noise, no leakage, and no impact. If there is any abnormality, it should be eliminated in time.

7. The fixed reducer is very important to ensure its stability and firmness. Generally speaking, the reducer should be installed on a horizontal foundation or base. At the same time, the oil in the oil tank should be discharged, and the cooling air should circulate smoothly. When the reducer is improperly fixed and the foundation is unreliable, vibration will occur, and unnecessary damage to bearings and gears will also be caused.

8. When installing the reducer, pay special attention to the alignment of the drive center shaft. The alignment error shall not exceed the use compensation of the coupling used by the reducer. After the reducer is aligned as required, the transmission effect is better and the service life is longer.

Right angle planetary reducer manufacturers will not introduce a lot today. I hope the above introduction will be helpful to everyone. If you still have problems that you don't understand, you can call our website online customer service to consult. Okay, I wish you a happy life.